Table of Contents
Advertisement
Connect the power cord after all other connections have been made.
Setting the voltage selector
(not applicable for Australia)
Before plugging in, select the voltage range for your area with the
voltage selector by using a screwdriver or a similar tool.
Main unit (rear)
CAUTION for mains (AC) line
BEFORE PLUGGING IN, do check that your mains
(AC) line voltage corresponds with the position
of the voltage selector switch provided on the
outside of this equipment and, if different, reset
the voltage selector switch, to prevent from a
damage or risk of fire/electric shock.
Connecting power cord
Be sure to connect the power cord to a wall outlet after all other
connections have been made.
• If a wall outlet does not
match the AC plug, use the
supplied AC plug adaptor (not
supplied for Saudi Arabian
and Australian models).
To wall outlet
Set the clock before using this
unit (refer to page 9).
Preparing remote control
When you use the remote control for the first time, pull out the insulation
sheet.
To replace the battery in the remote control
Caution
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• Store the battery in a place where children cannot reach.
If a child accidentally swallows the battery, consult a doctor
immediately.
• To prevent the battery from overheating, cracking, or starting a fire:
– Do not recharge, short, disassemble or heat the battery or dispose
of it in a fire.
– Do not leave the battery with other metallic materials.
– Wrap the battery with tape and insulate when throwing away or
saving it.
– Do not poke the battery with tweezers or similar tools.
• Dispose of battery in the proper manner, according to federal, state,
and local regulations.
• The battery (battery pack or battery installed) shall not be exposed to
excessive heat source such as sunshine, fire or the like.
5
Advertisement
Table of Contents
