Table of Contents
Advertisement
Troubleshooting
Troubleshooting
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If the unit does not work correctly, disconnect the AC power cord from the wall outlet, wait for a while, then connect the cord again.
Power does not come on.
Adjustments or settings are suddenly canceled
before you finish.
Unable to operate the unit from the remote
control.
No sound is heard.
Sound quality is low.
The iPod does not play, but "iPod" appears on
the display.
The disc/USB mass storage class device/SD card
does not play.
Symptoms
• Power plug is not inserted securely. Plug it in securely.
• There is a time limit. Start the procedure again.
• The path between the remote control and the remote sensor on the unit is
blocked.
• The battery is exhausted.
• Headphones are connected.
• Adjust the volume.
• The terminals or disc pickup lens is dirty. Clean them.
• The iPod battery is low or exhausted. Charge the iPod battery.
• Select the correct source — "DVD/CD, " "USB, " or "SD. "
• There is moisture condensation. Turn the unit on and wait for a few hours before
use.
• The disc is placed incorrectly. Place the disc with the label side facing forward.
• The disc is recorded using "packet writing (UDF file system). " It cannot be played.
• The disc is not be finalized correctly. Use finalized discs.
• The disc pickup lens is dirty. Clean it (Refer to page 25).
• The USB mass storage class device is not connected properly or the SD card is
not inserted properly.
• It is impossible to play USB mass storage class devices with a security function.
28
Causes/Remedies
Advertisement
Table of Contents
