Table of Contents
Advertisement
Instructions For Cleaning
3. Carefully pull back on the Burner Assembly, disengaging the venturi from
the Regulator Assembly. Please see Figure 10. Since the Ignitor is still
attached to the Burner Assembly, use care to avoid stressing the cable.
There is enough slack available to allow you to look into the end of the
venturi and clean with a pipe cleaner if needed.
4. When clean, carefully reassemble the Burner Assembly and Reflector,
making sure the mounting screws are tight and the venturi tube and clip
are properly connected to the Regulator Assembly.
5. Clean the outside of the Burner Assembly with a paper towel or damp
sponge. Open any clogged holes with a thin wire.
Storing Your Propane Grill
1. Clean the Grill as instructed above.
2. To transform the grill from the Grilling Position to Storage Position, fold in
the Side Trays, store the Drip Container inside the Grill Body, and close
the Cover. Unlock the Transport Handle/Drip Container Holder, and
remove the Grill Body from the Storage Case/Stand.
3. Open the Storage Case/Stand, and attach the Base Support Ring back to
the integral groove of Storage Case/Stand. Place the Grill Body inside the
Storage Case/Stand, close the cover, and lock the latches.
4. Store the propane cylinder outdoors in a well-ventilated space and out of
reach of children.
5. Cover grill when stored outdoors.
6. Store grill indoors only if the propane cylinder is turned off and discon-
nected, removed from grill and stored outdoors.
7. When removing grill from storage, follow the "Cleaning the Burner
Assembly" instructions before using the grill.
Any servicing requiring disassembly other than the above cleaning must be
performed by an authorized appliance repair technician.
Do NOT ship gas cylinder if product needs service or repair.
17
(Cont.)
Advertisement
Table of Contents
