Setting Hba Configuration By Using Qlogic - NEC Express5800/R320f-E4 Installation Manual

Chapter 1 Installing OS
1.7

Setting HBA configuration by using QLogic

1. Connect power cords in the following order to start the system from CPU/IO module 0.
(1) Connect a power cord to AC inlet A.
(2) Connect a power cord to AC inlet B.
2. Press the POWER switch that is located on the front side of the server.
In the QLogic prompt window which appears during POST, press Ctrl+Q or Alt+Q to launch
2-1
QLogic Fast! UTIL.
Express5800/R320e-E4, R320e-M4, R320f-E4, R320f-M4 Installation Guide (VMware)
Important Before setting the HBA configuration by using QLogic BIOS, it is required to
complete the storage settings such as creating a logical disk.

Note Wait at least 15 seconds after step (1), and then perform step (2).

If you disconnect a power cord, wait for at least 30 seconds before connecting it again.
Tips See Chapter 1 (1.2 Preparations for Setup) for AC inlet connector.
Important Make sure that the PRIMARY LED on CPU/IO module 0 is lit.
Note Make sure that Module POWER LEDs on both CPU/IO modules 0 and 1 are blinking, then
press the POWER switch.
1. Setup Procedure
27