IGMP Configuration Guide
Supermicro switches acts as a querier by default as long as it is a multicast router with a
lower IP address on the subnet.
1.3 IGMP Support
Supermicro switches support IGMP for all three IGMP versions (1, 2 and 3).
Supermicro switches support up to 255 multicast groups.
1.4 IGMP Defaults
Parameter
IGMP global status
IGMP status in VLAN
IGMP version
Query interval
Query max response time
Robustness value
Last member query interval
Immediate leave (fast leave)
Static multicast group membership
1.5 Enabling IGMP
IGMP is disabled by default in Supermicro switches.
IGMP must be enabled globally and individually in interfaces.
Follow the steps below to enable IGMP.
Step Command
Step 1
configure terminal
set ip igmp enable
Step 2
Step 3
interface <interface-type> <interface-id>
or
interface range <interface-type> <interface-id> ....
Default Value
Disabled
Disabled
2
125 seconds
100 seconds
2
10 seconds
Disabled
None
Supermicro L2/L3 Switches Configuration Guide
Description
Enters the configuration mode.
Enables IGMP globally.
Enters
the
interface
mode.
interface-type – may be any of the
following:
gigabit ethernet – gi-
extreme-ethernet – ex
configuration
7