Igmp Configuration Example - Supermicro SSE-G24-TG4 Configuration Manual

IGMP Configuration Guide
1.11

IGMP Configuration Example

Configure the following requirements as shown below in Figure IGMP-3.
Switch A:
1. Enable IGMP.
2. Configure the static multicast group and source on VLAN10.
3. Configure the immediate leave and query interval.
4. Verify the IGMP group table.
Switch B:
1. Enable IGMP.
2. Verify the IGMP group table.
3. Configure the robustness value.
Figure IGMP-3: IGMP Configuration Example
Gi 0/1
VLAN 10
VLAN 10
225.1.1.1
Receiver Hosts
When an MRP (such as PIM) is enabled on interfaces between Switch A and Switch B, traffic
will flow from source 200.1.1.1 to the receivers for group 225.1.1.1
Switch A
Gi 0/24
Gi 0/24
Supermicro L2/L3 Switches Configuration Guide
Trunk – po 1
Native VLAN 20
Source 200.1.1.1 for
Group 225.1.1.1
Switch B
27