Igmp Version - Supermicro SSE-G24-TG4 Configuration Manual

IGMP Configuration Guide
SMIS(config)#configure terminal
SMIS(config)#interface vlan 10
SMIS(config-if)# set ip igmp enable
SMIS(config-if)#end
SMIS# show ip igmp interface
vlan10, line protocol is up
Internet address is 2.2.2.2/8
IGMP is enabled on interface
Current IGMP router version is 2
IGMP query interval is 125 seconds
Last member query response interval is 10 seconds
IGMP max query response time is 100 seconds
Robustness value is 2
IGMP querying router is 2.2.2.2 (this system)
Fast leave is disabled on this interface
No multicast groups joined

1.6 IGMP Version

The IGMP protocol standard has three versions: v1, v2 and v3. Supermicro switches support IGMP for all
three versions. Supermicro IGMP support interoperates with different IGMP versions as defined in the
standard IGMP protocol.
The default IGMP version is v2, which is compatible with IGMP versions 1 and 3.
Supermicro switches provide the flexibility for users to configure different IGMP versions on different
interfaces.
Follow the steps below to change the IGMP version on any interface.
Step Command
Step 1 configure terminal
Step 2 interface <interface-type> <interface-id>
or
interface range <interface-type> <interface-id> ....
Description
Enters the configuration mode.
Enters
mode.
interface-type – may be any of the
following:
gigabit ethernet – gi
extreme-ethernet – ex
qx-ethernet – qx
vlan
interface-id is in slot/port format for all
physical interfaces. It may be the VLAN
Supermicro L2/L3 Switches Configuration Guide
the interface configuration
9