Igmp Snooping Configuration Example - Supermicro SSE-G24-TG4 Configuration Manual

IGMP Snooping Configuration Guide
show ip igmp snooping vlan <vlan>
Step 7 write startup-config
The example below shows the commands used to disable IGMP snooping.
Disable the IGMP snooping function assuming the switch has VLANs 1, 10 and 20.
SMIS# configure terminal
SMIS(config)# no ip igmp snooping
SMIS(config)# vlan 1,10,20
SMIS(config-vlan)# no ip igmp snooping
SMIS(config-vlan)# end
1.16

IGMP Snooping Configuration Example

Configure the following requirements on Switch A as shown below in Figure IGS-4.
1. Enable IGMP snooping.
2. There is no multicast router for group 225.0.0.1 so configure the switch as a querier for this
group.
3. Use IGMP v2 for group 225.0.0.1 and also enable fast leave since hosts are directly connected to
the switch.
4. Disable the proxy reporting.
5. Enable the switch to send general IGMP queries when spanning tree topology changes.
Optional step – saves this IGMP
snooping configuration to be part of
the startup configuration.
Supermicro L2/L3 Switches Configuration Guide 23