E N H A N C E D O T H E R N E T W O R K ( E O; P R O G R A M M E T Y P E ( P T; S E A R C H I N G F O R A P R O G R A M M E T Y P; Pty Activation / De-Activation - VDO CD2217G Manual

Hide thumbs Also See for CD2217G:
Table of Contents

Advertisement

Interrupting TA
lf you do not wish to continue li$tening to a par-
ticular Traffic Announcement broadcast, you can
interrupt it wilhoul switching off the TA mode.
1. Shorl-press the el.. button once. the hea-
dunit will return to the previous operating
mode.
Enhanced other Network (EON)
EON information allows the updating of RDS
information for programme services other than
the currently tuned station. By default, this EON
function is enabled. To toggle the settings:
1. Navrgate the SAM lo select lA EON .
2. Turn the knob clockwise / anti-clockwise to
toggle the modes (Off, Local or Distant).
Note: The reception of distant stations. which
may be weaker due to its distance, may be bad
and the audio output may be distorted as a re-
sutL
Programme Type (PTY)
This function is available with FM only. lt enables
you to select stations by programme type. There
is a coding of up to 28 pre-defined programme
types - e.g. (in Europe): Pry1 News, PTY6
Drama, PTY11 Rock music.
Searching for a Programme Type
'1. Long-press
ff button to activate the PTY
function.
2. Short-press either A button or V button to
select the desired programme type.
3. Short-press either )> button or << button
to search for PTY stations.
PTY Activation / De-activation
To change the operation mode of the PTY you
need to change the setting in the SAM.
'1 . Navigate the SAM
to select 'PTY'.
2. Turn the knob clockwise / anti-clockwise to
toggle the PTY setting.
Note: Setting 'Pry menu item to'NEWS INT'
will allow PTY-NEWS to interrupt (in a similaf
way as TA interruption
) when there is an incom-
ing NEWS.
RDS Regionalization
To change the way this headunit reacts to the
environmental conditions affecting the quality of
the radio stations, you can change the setting 'n
the SAM.
1. Navigate the SAIV to select 'REG-RDS'.
2. Turn the knob clockwise / anti-clockwise to
toggle the REG-RDS setting.
2 .
3 .
CD OPERATION
Loading CD into the Headunit
1. lf not already on, short-press the ,iY+ button
to turn on the headunit.
Press the tl) button to flip down Lhe front.
Insed the CD (labelfacing up) into the CD
slot-
4. Close the front.
5. The display should show "CD READ" while
stillreading the disc.
When a disc is loaded, it will start playing auto-
matically.
Noter lf a CD does not automatically
load, DO
NOT FORCE it into the slot. This could damage
the CD and the headunit.
Ejecting a CD
1 . Press the REL button to flip down the front.
2. Press the EJECT button to eject the disc.
3. Remove the disc.
4. Close the front.
Playing a CD-R or CD-RW
Depending on the type of CD-R / CD-RW CD,
surface condition of the disc, as well as the per-
formance and condition of the CD writer, certain
CD-R / CD-RW CD may not operate normally on
this headunit.
Playing a "Copy.Protected" non-
conforming audio CD
Due lo the use of copy protection schemes of
some audio CDs, which are non-conforming to
international audio CDs standards (Red Book),
these types of copy-protected disc(s) may not
play on this headunit.
In the case of multi-session disc with such
schemes. you may try to disable the multi-ses-
sion ability by changing the SAI\,4 setting to allow
reading of at least the first session.
1. Navigate the SAM to select 'MULTI-S'.
2. Turn the knob clockwise / anti-clockwise to
toggle the multi-session support.
Try playing the "copy-protected disc again.
Note: Remember [o enable lhe multi-session
support again in the SAI\,4 after playing this discl
20

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cd2737bCd 2327 gCd 2537 u

Table of Contents