Table of Contents
Advertisement
SA-AK23 0GCP
10.2. Gear for servicing (jig) Information
1. This unit has a gear which is used for checking items (Open/Close of disc tray, up/down operation of traverse unit by manually)
when servicing.
2. For preparation of gear (for servicing), perform the procedures as follows.
3. In case of re-servicing the same set, the "gear for servicing" may has been taken off because it has been used. The "gear for
servicing" must be stored.
· Remove the gear provided with mecha cover as shown below.
· Insert the hexagonal screwdriver (2mm) into the gear, and then project the tip of screwdriver for 1~ 2 mm in length.
12
Advertisement
Table of Contents
