Kenwood NX-P500 User Manual page 45

Function name
Individual Reply
Maintenance
Monitor
Monitor
Momentary
Scan
Scan Delete/ Add
Second PTT
Speaker
Attenuation
Squelch Off
Squelch Off
Momentary
Display
When you receive a Group Call,
etc., while you are displaying the ID
of the caller, you can call Individual
Call to the caller by pressing
the button that programmed this
function and then pressing PTT
switch.
Enter Maintenance Display Mode
and display the signal strength
numerically.
Turns the transceiver signaling
off, to listen to all calls that are
received on the channel. Press this
button again to turn the transceiver
signaling back on.
Refer to {p.20}.
Turns the transceiver signaling off
while holding down this button.
Release this button to turn the
transceiver signaling back on.
While signaling is off, you can
listen to all calls that are received
on the channel.
Refer to {p.20}.
Press this button to start scanning
the transceiver channels. Refer to
{p.34}.
Adds or removes the selected
Channel to or from the scan
sequence.
Apart from the channel you
normally select, you can set up
another channel as the main
channel with a dedicated PTT
switch. Refer to {p.47}.
Speaker Attenuation
Press to hear background noise.
Press this button again to return
to normal operation. Refer to
{p.20}.
Continuously hold down this
key to hear background noise.
Release this key to return
to normal operation.
{p.20}.
Press
Refer to
45
Hold
None
None
None
None
Adds or removes the
selected Channel
to or from the scan
sequence.
None
None
None
None
None