Troubleshooting - Sagem myC-1 Owner's Manual

Sagem mobile phone owner manual
Table of Contents

Advertisement

Troubleshooting

Problem - Situation
The phone does not turn on
No network recognised
Calls to a messaging service or voice
server do not get through
Unable to turn the phone on
Error message:
BATTERY STATUS NOT KNOWN
Error message: LOW BATTERY
myC-1_en_15dépannage.pmd
Actions
Remove the battery and then replace it.
or
Connect the phone to the charger (check that this is
plugged in) for approximately 5 minutes.
Remove the SIM card. Check that there is no dust or
grit in the SIM slot. Replace the SIM card being sure
to push it right up to the stop point.
Check in the Ringing and beeps/Tones menu that the
box is ticked.
Charge the phone for 15 minutes before turning it on.
Check the battery charging indicator:
cycling: charging normally
not cycling: disconnect the charger, re-connect and
then check the battery charging indicator: if it is still
not cycling, disconnect the charger and re-connect
several times.
If the battery is still not charging, contact the after
sales service.
When the battery charging indicator is continuously
on, the battery is fully charged.
The battery pack is not recognised by the phone.
Check that the battery pack is correctly fitted in the
phone.
This message is displayed when the battery charge is
too low. The phone turns off automatically. Charge
the phone.
55
55
22/12/2003, 16:17

Advertisement

Table of Contents
loading

Table of Contents