Superior BRT2032TMN Installation And Operation Instructions Manual page 19

TO TURN OFF GAS
TO APPLIANCE
1. Turn off wall switch (if installed).
2. Turn off all electric power to appliance if service is to be per-
formed.
3. Fully open glass doors if installed.
4. Remove front hearth brick and control access panel.
5. Turn gas control knob clockwise
6. Replace front refractory brick access panel.
7. Fully close glass doors if installed.
Pilot
Burner
Igniter
Figure 34 - Pilot
126745-01E
OPERATION
to OFF. Do not force.
Thermopile
SuperiorFireplaces.us.com
Continued
OPTIONAL HAND-HELD
REMOTE OPERATION
NOTE: Receiver and hand-held remote control kit must be purchased
separately (see Accessories, Page 23). Follow installation instructions
included with the remote control.
1. After lighting, let pilot flame burn for about one minute. Turn
control knob to ON position. Slide the selector switch to the
REMOTE position. NOTE: Burner may light if hand-held remote
ON button was on when selector switch was last turned off. You
can now turn burner on and off with hand-held remote control
unit.
IMPORTANT: Do not leave selector switch in the REMOTE position
when pilot is not lit. This will drain battery.
IMPORTANT: Be sure to press ON/OFF buttons on hand-held
remote control unit for up to 3 seconds to assure proper opera-
tion.
2. Press ON/OFF button to turn the burner on and off. When turning
burner off, pilot will remain lit.
IMPORTANT: To turn pilot off, manually turn control knob on
fireplace to OFF position.
3. To leave pilot lit and shut off burners only, turn remote control /
wall switch (if installed) to the OFF position.)
TO TURN OFF GAS
TO APPLIANCE
1. Press in and turn control knob clockwise
tion.
2. Close equipment shutoff valve
Check pilot flame pattern and burner flame patterns often.
to the OFF posi-
19