Table of Contents
Advertisement
3. Carefully slide the enclosure into the rack along the rails until the enclosure is
Figure 18. Inserting the enclosure
4. Secure the enclosure with screws in the rack mounting screw holes. (See
5. Reinstall the left and right end caps. (See Figure 19 on page 21.) The left end
20
Storwize V7000 Gen2: Quick Installation Guide
fully inserted (see Figure 18).
Note: The rails are not designed to hold an enclosure that is partially inserted.
The enclosure must always be in a fully inserted position. Control enclosures
must only be installed on the supplied control enclosure rails. Expansion
enclosures must only be installed on the supplied expansion enclosure rails.
Figure 18 and Figure 19 on page 21.)
cap has indicator windows that align with the status LEDs (light-emitting
diodes) on the edge of the enclosure.
a. Ensure that the serial number of the end cap matches the serial number on
the rear of the enclosure.
b. Fit the slot on the top of the end cap over the tab on the chassis flange.
c. Rotate the end cap down until it snaps into place.
d. Ensure that the inside surface of the end cap is flush with the chassis.
1
2
Advertisement
Table of Contents
