Identifying The Hardware Components; Rear View Of A Storwize V7000 Control Enclosure; Data Ports In The Rear Of The Control Enclosure - IBM Storwize V7000 Gen2 Quick Installation Manual

Identifying the hardware components

The following graphics and descriptions identify the various hardware components
and port locations for the control enclosure and expansion enclosure.
Control enclosure components
Figure 1 shows the rear view of a control enclosure and identifies the location of
the power supply units and node canisters.
Figure 1. Rear view of a Storwize V7000 control enclosure
v
v
Figure 2 shows the rear view of a Storwize V7000 control enclosure and identifies
the location of the ports.
Figure 2. Data ports in the rear of the control enclosure
v
v
6
Storwize V7000 Gen2: Quick Installation Guide
1 Node canisters
2 Power supply units
2 1
3
1 USB ports. Each canister has two USB ports.
2 Ethernet ports. Each canister has four 1 Gbps Ethernet ports.
Port 1 Must be connected for system management. Can optionally be used for
iSCSI host connectivity.
Port 2 Optional. Can be used for iSCSI host connectivity or to provide an
alternative (redundant) management address.
Port 3 Optional. Can be used for iSCSI host connectivity.
Port T Technician port. Can be connected directly to a computer for service
access and system initialization.
1
2