Cutting Warped Material; Operation; Clamping Wide Workpieces - Ryobi TS1301 Operator's Manual

CUTTING WARPED MATERIAL

See Figures 27 and 28.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side against the
fence as shown in figure 27.
If the warped material is positioned the wrong way as shown
in figure 28, it will pinch the blade near the completion of the
cut.
WARNING:
To avoid a kickback and to avoid serious personal injury,
never position the concave edge of bowed or warped
material against the fence.

CLAMPING WIDE WORKPIECES

See Figure 29.
When cutting wide workpieces that are too wide to be
clamped with a work clamp, a C-clamp must be used. For
example, when cutting 2 in. x 6 in. boards, they should be
clamped with a C-clamp as shown in figure 29.

OPERATION

Page 20
RIGHT
WRONG
WIDE
BOARD
8
7
6
5
4
3
2
1
C-CLAMP
Fig. 27
Fig. 28
Fig. 29