Ryobi SS50 Operator's Manual page 10

REMOVING DEPTH ADJUSTMENT RING
See Figure 4.
Follow these directions when removing the depth
adjustment ring.
■ Place wrench in tab on depth adjustment ring.
■ Depress spring-loaded tab.
■ Lift depth adjustment ring off of tool.
ASSEMBLING CIRCLE CUTTER
See Figure 5.
Follow these directions when assembling the circle
cutter.
■ Attach handle with screw provided.
■ Attach pivot point knob with nut provided.
ATTACHING CIRCLE CUTTER
See Figure 6.
Follow these directions when attaching the circle cutter.
■ UNPLUG YOUR SPEED SAW.
WARNING:
Failure to unplug your Speed Saw could result in
accidental starting causing serious injury.
■ Assemble circle cutter if necessary. Refer to "AS-
SEMBLING CIRCLE CUTTER" previously.
■ Remove bit if necessary. Refer to "INSERTING/
REMOVING BITS" earlier in this manual.
■ Place adaptor under depth adjustment ring.
NOTE: Make sure the adaptor fits snugly.
■ Place circle cutter arm on top of depth adjustment
ring.
■ Screw threaded ring onto adaptor, securing circle
cutter arm.
■ Insert bit. Refer to "INSERTING/REMOVING BITS"
earlier in this manual.
ADJUSTMENTS
HANDLE
10
TAB
WRENCH
SCREW
NUT
PIVOT
POINT KNOB
THREADED
RING
DEPTH
ADJUSTMENT
RING
ADAPTOR
Fig. 4
Fig. 5
CIRCLE
CUTTER
ARM
Fig. 6