Blades; Features - Ryobi BTS20 Operator's Manual

BLADES

It is recommended that you use a RYOBI 10 in. (254 mm) Combination Blade, which is provided with the BTS20 Table Saw.
You will get maximum performance with the following features:
• 36 precision ground, micro-grain carbide teeth
• tensioning for 4,800 rpm
This blade is provided with the saw. Additional blade styles of the same high quality are available for specific operations
such as ripping. Your local RYOBI dealer can provide you with complete information.
CAUTION:
Be sure to use only blades that are rated for at least 5,500 RPM and recommended for use on this saw.
PRECISION GROUND
MICRO-GRAIN
CARBIDE TEETH
SPEED AND WIRING
The no-load speed of your table saw is approximately 4,800
rpm. The speed will not remain constant but will be less
under a load. The wiring in a shop is as important as the
motor's horsepower rating. A line intended for lights only
WILL NOT PROPERLY CARRY A POWER TOOL MOTOR.
Wire that is heavy enough for a short distance will be too light
for a greater distance. A line that can support one power tool
may not be able to support two or three tools.

FEATURES

• kerf width of 2.5 mm + .02
WARNING:
To prevent possible electrical hazards, have a qualified
electrician check the line if you are not certain that it is
properly wired.
Page 13
BLADE
ROTATION
Fig. 6