Blades; Fig. 7; Features - Ryobi BT3100K Owner's Operation Manual

BLADES

It is recommended that you use only the RYOBI 254mm (10in) Combination Blade, which is for use with the BT3100K Table
Saw. You will get maximum performance with the following features:
• 36 precision ground, micro-grain carbide teeth
• kerf width of 2.5 mm + .02
This blade is provided with the saw. Additional blade styles of the same high quality are available for specific operations such
as ripping. Your local RYOBI dealer can provide you with complete information.
CAUTION:
Be sure to use only blades that are rated for at least 5,500 RPM and recommended for use on this saw.
PRECISION GROUND
MICRO-GRAIN
CARBIDE TEETH
SPEED AND WIRING
The no-load speed of your table saw is approximately 4,800
rpm. The speed will not remain constant but will be less
under a load. The wiring in a shop is as important as the
motor's horsepower rating. A line intended for lights only
WILL NOT PROPERLY CARRY A POWER TOOL MOTOR.
Wire that is heavy enough for a short distance will be too light
for a greater distance. A line that can support one power tool
may not be able to support two or three tools.

FEATURES

• laser-cut expansion slots
• tensioning for 4,800 rpm
WARNING:
To prevent possible electrical hazards, have a qualified
electrician check the line if you are not certain that it is
properly wired.
Page 13
LASER-CUT BODY
AND EXPANSION SLOTS
BLADE ROTATION

Fig. 7