Static Router Port - Supermicro SSE-G24-TG4 Configuration Manual

IGMP Snooping Configuration Guide
The example below shows the commands used to configure the router port timeout value.
Configure the router port timeout value as 90 seconds.
SMIS# configure terminal
SMIS(config)# ip igmp snooping mrouter-time-out 90
SMIS(config)# end
1.6.2 Static Router Ports
Router ports can also be configured statically. Router ports are configured per VLAN basis.
Follow the steps below to configure the static router port for any VLAN.
Step Command
Step 1 configure terminal
Step 2 vlan <vlan-list>
ip igmp snooping mrouter <interface-type>
Step 3
<interface-id>
Step 5 end
Step 6 show ip igmp snooping mrouter [vlan <vlan>]
Description
Enters the configuration mode.
Enters the VLAN configuration mode.
vlan-list – may be any VLAN number or
list of VLAN numbers. Multiple VLAN
numbers can be provided as comma-
separated values. Consecutive VLAN
numbers can be provided as a range,
such as 5-10.
If multiple VLANs are provided, the next
step will configure the router ports for
all these VLANs.
Configures the router port.
interface-type – may be any of the
following:
gigabit ethernet – gi
extreme ethernet – ex
qx ethernet – qx
port channel – po
interface-id is in slot/port format for all
physical interfaces. It may be the port
channel identifier for port channel
interfaces.
Exits the configuration mode.
Displays the IGMP snooping router port
information. If a VLAN identifier is
provided it displays the router port for
the given VLAN. If a VLAN identifier is
not provided it displays the router ports
Supermicro L2/L3 Switches Configuration Guide 10