Advertisement
CAUTION: Do not drag the bag when
you empty the grass catcher to prevent
wear.
To change the cutting mode
The product can be changed to one of three different
cutting modes while in operation by pressing the
cutting mode button.
•
Auto mode - The product automatically adjusts
the cutting speed of the product in response to
the quantity of grass being cut.
•
Note: The product is set to Auto mode by
default while in operation.
•
Boost mode - The product operates at high
speed regardless of the quantity of grass being
cut.
•
While the product is in operation, press the
cutting mode button one time to change from
Auto mode to Boost mode. The cutting mode
button then illuminates.
•
ECO mode - The product operates at low speed
regardless of the quantity of grass being cut.
•
While the product is in operation, press the
cutting mode button one time to change from
Boost mode to ECO mode. The cutting mode
button then illuminates and flashes.
•
To go back to the default Auto mode, press
the cutting mode button one time while the
product is in operation. The cutting mode
button then stops flashing.
Note: If the motor control handle is released during
operation, the product stays in the current cutting
WARNING: Read and understand the
safety chapter before you clean, repair
or do maintenance on the product.
General recommendations for
maintenance
The warranty on this product does not include
incorrect or not careful operation of the product by
the operator. To receive full value from the warranty,
the operator must do maintenance on the product as
written in the instructions of this manual. Different
adjustments must be made at different intervals to
keep your product in correct work condition.
•
Examine the blade for wear each year.
To examine the tires
•
Keep the tires free of unwanted material and
chemicals to prevent damage to the rubber.
355 - 002 - 03.10.2017
mode. If the product automatically stops, or the
operator presses the power button, the cutting mode
used before is erased from memory and the product
starts in Auto mode when started again.
Battery status indication during
operation
The display on the user control interface shows the
battery capacity and if there are problems with the
battery pack. The battery capacity is shown while the
machine is in operation.
LED lights
All Green
LEDs come
on
LED 1, 2 and
3 come on
LED 1 and 2
come on
LED 1 comes
on
LED 1 flashes The battery pack is 5% - 0% charg-
If there is an error with the battery pack during
operation, all four green LEDs of the battery state of
charge display flash. Remove the battery pack from
the machine and press the indicator button on the
battery pack to show the error code for the error. The
LED's on the battery pack illuminate and show an
error code if an error has occurred. Consult the
battery manual for a list of error codes and solutions
to the errors.
MAINTENANCE
•
Keep the tires away from stumps, stones, ruts,
sharp objects and other objects which can cause
damage to the tires.
To do a general inspection
•
Check that nuts and screws are tight.
•
Make sure no cables are pinched.
Maintenance schedule
Use the maintenance schedule to see the necessary
maintenance requirements of your product, and
when the maintenance must occur. The intervals are
calculated on average use of the product and may
be different because of how frequently you use it.
•
Tighten bolts and nuts before each use and
before storage.
•
Clean and examine the grass catcher, if installed,
before and after each use, and before storage.
•
Examine the tires before each use.
•
Clean the product after each use and before
storage. Use a scraper to clean below the deck.
Battery status
Fully Charged (100% - 76%)
The battery pack is 75% - 51%
charged.
The battery pack is 50% - 26%
charged.
The battery pack is 25% - 6%
charged.
ed.
9
Advertisement
