Operation - Ryobi HP1202M Operator's Manual

KNOW YOUR DRILL-DRIVER
See Figure 1.
Before attempting to use any tool, familiarize yourself with all
operating features and safety requirements.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict severe injury.
CHARGING YOUR DRILL-DRIVER
The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it overnight prior to use.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (drilling followed by re-
charging) for them to fully charge.
TO CHARGE
■ Charge battery pack only with the charging assembly
provided.
■ Make sure power supply is normal household volt-
age, 120 volts, 60 Hz, AC only.
■ Connect charging assembly to power supply.
■ Place battery pack in charging assembly. Align raised
rib on battery pack with groove in charging assembly.
See Figure 2
.
■ Press down on battery pack to be sure contacts on bat-
tery pack engage properly with contacts in charging as-
sembly. When properly connected, red light on charging
assembly will turn on.
Note: During the two year warranty period, if the charge
indicator light (LED) fails to come on or goes out while
charging battery pack, return charging assembly and
battery pack to your nearest authorized service center
for repair or replacing.
■ After normal usage, 3 hours or less of charging time is
required to fully recharge battery pack. Note: If battery
pack is completely discharged, 6 hours or longer of
charging time is required to fully recharge battery
pack.
■ The battery pack will become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
■ DO NOT place charging assembly in an area of ex-
treme heat or cold. It will work best at normal room
temperature.
■ When battery pack has been charged, disconnect charg-
ing assembly from power supply and remove the bat-
tery pack. This practice will increase battery life.

OPERATION

TORQUE
ADJUSTMENT
RING
KEYLESS
CHUCK
MAG TRAY™
(Model HP1202M)
CHARGING
ASSEMBLY
Page 7
LEVEL
SWITCH
TRIGGER
BATTERY
PACK
BIT
STORAGE
AREA
DIRECTION OF
ROTATION
SELECTOR
BATTERY
PACK
Fig. 1
CHARGE
INDICATOR
LIGHT (LED)
Fig. 2