Table of Contents
Advertisement
Gps Logistic
First run
The device is supplied in a form ready for use, the only steps you must take are:
insert SIM card
,
1
connect power supply,
Set (via SMS) following properties:
owner's phone number,
1.
operator APN,
2.
IP address of the storage server
3.
Configuration can be done by sending SMS messages from any cell-phone, or in the 3-th party service
indicated by an authorized distributor.
After properly installing the device in
vehicle follow these steps in the order:
Send SMS to the tracker containing:
1.
.setc UserTel +48xxxxxxxxx
where:
xxxxxxxxx - 9 digit owner's phone number
Send SMS to the tracker containing:
2.
.setc GPRS_APN "apn","login","password"
where:
apn Operator's Access Point Name
login Operator's APN login
password Operator's APN password
Send SMS to the tracker containing:
3.
.testgprs
When the device receives this message, immediately tries to connect to the server, then answer
to the owner's phone with relevant message. Response time depends on the operator rather
than the device itself. Time waiting for a response should be less than 3 minutes, but there are
cases (the GSM network overload), in which it can take up 10min.
If the device responded to a message with
"Connection ok" means that the configuration has been carried out properly and the device is
ready for use.
If the device responds other than this message, please go to the "Troubleshooting"
1Depending on the distributor's offer, the device can be supplied with or without a SIM card installed.
3
Advertisement
Table of Contents
