Toshiba RAV-RM301SDT-E Service Manual page 88

No. Part name
1. Detachment
E-cover
3
1) Perform work 1. of
2) Take off screws fixing E-cover, and then
2. Attachment
1) Hang on E-cover to hooks of the hooking part
NOTE)
Be sure not to catch TA sensor in the E-cover;
otherwise the equipment cannot operate cor-
rectly.
2) Using the screws taken off in procedure 1. 2)
NOTE)
If there is clearance, dust may enter in the electric
parts box.
1. Detachment
E-box
4
1) Perform works 1. of
2) Remove clamps and tie wrap at upper part of
3) Take off screws fixing E-box. (Ø4 × 10, 2 pcs)
4) Remove the E-box over sheeting metal which
2. Attachment
1) Insert hooks of E-box into the hooking part of
2) Store E-box as before, and then attach it by
NOTE)
Be sure to fix surely as before the lead wires of
which clamps and tie wrap were taken off.
NOTE)
Check that lead wires of the drain pump do not
reach the fan so that they are not caught in the
fan, and then fix them.
(In case of drain pump incorporated model)
Procedure
2 .
remove hooks of the hooking part by lifting up.
(Ø4 × 10, 2 pcs)
so that it does not fall down.
3
of , attach E-cover while holding it with
hands without clearance.
2 and 1. of
the photo. (Drain pump incorporated model: 3
positions)
(Natural drain model: 2 positions)
E-box does not fall down under condition that
screws are taken off.
was fixed with screws.
the main body.
using screws taken off in procedure 1. 3) of
4 .
TA sensor
3 .
Drain pump
Lead wire:
For only drain pump incorporated model
– 88 –
Remarks
E-cover E-cover E-cover
2 screws
Hooking part
E-cover E-cover E-cover
Clamp
Tie wrap Tie wrap Tie wrap
2 screws
Clamp