Toshiba RAV-RM301SDT-E Service Manual page 73

<Wireless remote controller>
Wireless remote controller A-B selection
Using 2 wireless remote controllers for the respective air conditioners, when the 2 air conditioners are closely
installed.
Wireless remote controller B setup
1. Push the START/STOP button to operate the air conditioner. Push it again to stop the air conditioner.
2. Push [Temporary] button on the signal receiving unit to operate the air conditioner.
3. Point the wireless remote controller at the indoor unit.
4. Push and hold
CHK
the display.
5. Push the MODE
MODE
"B" will be shown on the display and "
wireless remote controller B is memorized.
"B" Display
00
" " Display
Note:
• Repeat above step to reset wireless remote controller to be A.
• The wireless remote controllers do not display "A".
• The factory default of the wireless remote controllers is "A".
button on the wireless remote controller by the tip of the pencil. "
button during pushing
CHK
00
" will be disappear and the air conditioner will turn OFF. The
.
– 73 –
00
" will be shown on
TEMPORARY button