Advertisement
Installation Instructions for Baby Trend
The Double Snap-N-Go
Seat. Please follow the following instructions for proper installation of the
Latch Loc.
Front Seat:
1. Remove (unscrew) Crossbars A1, B1, and C and D from the Double
frame Remove the Car Seat Straps from the Double Snap-N-
Snap-N-Go
®
Go
frame. Retain the screws you remove.
®
2. Attach the Car Seat Straps to the Double Snap-N-Go
two holes labeled #5 as shown in figure 1. Use the two screws that you
removed in step 1.
3. Attach Crossbar C, to the Double Snap-N-Go
labeled #7 as shown in figure 1.
Rear Seat:
1. Remove (unscrew) Crossbars A 2, B2 and B1 from the Double Snap-N-
frame. See figure 2.
Go
®
Insertion of the Latch-Loc
1. With one hand grasp the car seat handle (in its upright, carrying position)
and gently place the seat, so that the baby faces the rear of the Double
, onto the Double Snap-N-Go
Snap-N-Go
®
seat bottom, nearest the head-end of the seat, hooks over Crossbar BT1
in the front or crossbar BT2 in the rear. Check that the seat locked onto
the Crossbar. See Figure 3.
IMPORTANT THAT THE SEAT LOCK SECURELY ONTO THE
CROSSBAR.
2. Feed the Car Seat Straps through the auto belt slots on the infant car
seat as shown in Figure 4 and snap the two buckles together. The
first time your do this, you will need to adjust the length of the strap
for a tight fit around the car seat.
VERY IMPORTANT THAT THE CAR SEAT STRAP IS ALWAYS
TIGHTLY FASTENED OVER THE CAR SEAT.
3. Test for secure installation by moving the car seat in all directions. The
car seat should be securely attached to the Double Snap-N-Go
Removal of the Latch-Loc
1. Unlock the Car Seat Strap and remove from over the infant car seat.
2. With one hand, grasp the car seat handle (in its upright, carrying position)
and with your other hand squeeze the handle on the front of the car seat
and lift the car seat upward from the Double Snap-N-Go
Figure 5.
Baby Trend
and Latch-Loc
®
not associated with Baby Trend and no approval or endorsement is implied.
will accommodate the Latch-Loc
®
Infant Car Seat
®
so that the large groove on the
®
FOR SAFE OPERATION, IT IS VERY
FOR SAFE OPERATION, IT IS
Infant Car Seat:
®
are the trademarks of their owners. They are
Latch-Loc
®
®
Infant Car
®
frame using the
®
frame using the two holes
®
.
®
frame. See
®
Hole #7
Hole #5
Bar C
Strap
Fig. 1
Hole #5
BT2
Strap
Fig. 2
Fig. 3
Fig. 4
Fig. 5
BT1
14
Advertisement
