Advertisement
Installation Instructions for Evenflo
The Double Snap-N-Go
Carry Infant Car Seat. Please follow the following instructions for proper
installation of the Cozy Carry.
Front Seat:
1. Remove (unscrew) Crossbars A1, B1, C, and D from the Double Snap-N-
frame. Retain the screws you remove.
Go
®
2. Attach Crossbar C to the Double Snap-N-Go
labeled #4 as shown in figure 1. Use the two screws that you removed
in step 1.
3. Attach Crossbar D, so that the bent section faces down, to the Double
frame using the two holes labeled #5 as shown in figure 1.
Snap-N-Go
®
Use the two screws that you removed in step 1.
Rear Seat:
1. Remove (unscrew) Crossbars A2, B2, and B1 from the Double Snap-N-
frame. Retain the screws you remove.
Go
®
2. Attach Crossbar B2 to the Double Snap-N-Go
labeled #2 as shown in figure 2. Use the two screws that you removed
in step 1.
3. Attach Crossbar B1, so that the bent section faces down, to the Double
Snap-N-Go
frame using the two holes labeled #4 as shown in figure 1.
®
Use the two screws that you removed in step 1.
Insertion of the Evenflo
1. With one hand grasp the car seat handle (in its upright, carrying position)
and gently place the seat, so that the baby faces the rear of the Double
, onto the Double Snap-N-Go
Snap-N-Go
®
seat bottom, nearest the head-end of the seat, hooks over Crossbar C1
in the front or crossbar B2 in the rear. Check that the seat locked onto
the Crossbar. See Figure 3.
IMPORTANT THAT THE SEAT LOCK SECURELY ONTO THE
CROSSBAR.
2. Loop the two ends of the Car Seat Strap (attached to the Double Snap-
frame) over the car seat, half way between the handle and the
N-Go
®
foot-end of the seat, and snap the two buckles together (see Figure 4).
The first time your do this, you will need to adjust the length of the strap
for a tight fit around the car seat.
VERY IMPORTANT THAT THE CAR SEAT STRAP IS ALWAYS
TIGHTLY FASTENED OVER THE CAR SEAT.
3. Test for secure installation by moving the car seat in all directions. The
car seat should be securely attached to the Double Snap-N-Go
Removal of the Evenflo
1. Unlock the Car Seat Strap and remove from over the infant car seat.
2. With one hand, grasp the car seat handle (in its upright, carrying position)
and with your other hand squeeze the red handle on the back of the car
seat and lift the car seat upward from the Double Snap-N-Go
See Figure 5.
Evenflo
and Cozy Carry
®
associated with Baby Trend and no approval or endorsement is implied.
will accommodate the new Evenflo
®
Cozy Carry Infant Car Seat
®
so that the large groove on the
®
FOR SAFE OPERATION, IT IS VERY
FOR SAFE OPERATION, IT IS
Cozy Carry Infant Car Seat
®
are the trademarks of their owners. They are not
Cozy Carry
®
®
frame using the two holes
®
frame using the two holes
®
.
®
frame.
®
Hole #6
Hole #5
Cozy
Bar D-down
Strap
Hole #5
Hole #4
Strap
Bar B1
Hole #4
Bar C
Fig. 1
Hole #2
Bar B2
Fig. 2
Fig. 3
Fig. 4
Fig. 5
10
Advertisement
