Advertisement
Installation Instructions for Evenflo
The Double Snap-N-Go
Infant Car Seat.
Please follow the following instructions for proper
installation of the On My Way.
Front Seat:
1. Remove (unscrew) Crossbars A1, C, B1 and D from the Double Snap-N-
frame. Remove the Car Seat Straps from the Double Snap-N-Go
Go
®
frame. Retain the screws you remove.
2. Attach Crossbar B1 with sleeve to the Double Snap-N-Go
the two holes labled #4 as shown in figure 1. use the two screws that you
removed in step 1.
3. Attach Crossbar C to the Double Snap-N-Go
labeled #6 as shown in figure 1. Use the two screws that you removed in
step 1.
4.Attach the Car Seat Straps to the Double Snap-N-Go
holes labeled 5 as shown in figure 1. Use the two screws that you removed
in step 1.
Rear Seat:
1. Remove (unscrew) Crossbars A2, B2, and B1 from the Double Snap-N-
frame. Retain the screws you remove.
Go
®
2. Attach Crossbar B2, so that the bent section faces down, to the Double
frame using the two holes labeled #3 as shown in figure 2.
Snap-N-Go
®
Use the two screws that you removed in step 1.
Insertion of the Evenflo
1. With one hand grasp the car seat handle (in its upright, carrying position)
and gently place the seat, so that the baby faces the rear of the Double
, onto the Double Snap-N-Go
Snap-N-Go
®
the seat bottom, nearest the head-end of the seat, hooks over Crossbar
C in the front or crossbar B2 in the rear. Check that the seat locked onto
the Crossbar. See Figure 3.
IMPORTANT THAT THE SEAT LOCK SECURELY ONTO THE
CROSSBAR.
2. Feed the Car Seat Straps through the auto belt slots on the infant car seat as
shown in Figure 4 and snap the two buckles together. The first time your
do this, you will need to adjust the length of the strap for a tight fit around
the car seat.
FOR SAFE OPERATION, IT IS VERY IMPORTANT
THAT THE CAR SEAT STRAP IS ALWAYS TIGHTLY FASTENED
OVER THE CAR SEAT.
3. Test for secure installation by moving the car seat in all directions. The
car seat should be securely attached to the Double Snap-N-Go
Removal of the Evenflo
1. Unlock the Car Seat Strap and remove from over the infant car seat.
2. With one hand, grasp the car seat handle (in its upright, carrying position)
and with your other hand squeeze the red handle on the back of the car
seat and lift the car seat upward from the Double Snap-N-Go
Figure 5.
Evenflo
and On My Way
®
associated with Baby Trend and no approval or endorsement is implied.
will accommodate the Evenflo
®
On My Way Infant Car Seat
®
®
FOR SAFE OPERATION, IT IS VERY
On My Way Infant Car Seat
®
are the trademarks of their owners. They are not
On My Way
®
On My Way
®
frame using
®
frame using the two holes
®
frame using the two
®
so that the large groove on
.
®
frame. See
®
Hole #6
Hole #5
Bar C
Strap
®
Fig. 1
Hole #5
Hole #3
Strap
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Hole #4
Bar B1
Sleeve
Bar B2
down
11
Advertisement
