Warranty - Russound CA-Series Instruction Manual

COMBINING ADDITIONAL IR RECEIVERS
When combining a CA Series multi-source controller and a
secondary IR system together, it needs to be done after the
CA System. The IR information from the keypad is on Pin #2.
This signal is demodulated at the keypad and is re-modulat-
ed at the processor then sent to the emitter out-puts.
Combining a modulated IR signal to this lead (#2) will not
work because it is already modulated. The following method
should be used to assure correct integration with such com-
ponents.
The emitter outputs on the CA Series are wired in series, so
#1 must be used first in order to obtain a signal. Simply plug
the IR linking cable supplied with the CA product into emit-
ter port #1. and plug the other end into the Russound 857
IR Connecting Block's "IR Common In". The secondary IR
receiver can either be wired to the terminal block as shown
or plugged into the "IR Reciever In" via a 1/8" mini-plug. The
emitters that would have been connected directly to the CA
system will now be plugged into the connecting block.
This method combines the modulated IR signal at the con-
necting block then distributes it to the four emitter ports.
The power supply shown (846C) would only be required if
the second IR receiver(s) needed it.
This method would also be used when connecting multiple
CA systems together. The IR Link is only designed for two CA
systems being that it conveys demodulated IR data between
the systems.
The Russound CA-Series Controllers are fully guaranteed for Two (2) years from the date of purchase against all defects in
materials and workmanship. During this period Russound will replace any defective parts and correct any defect in workman-
ship without charge for either parts or labor. For this warranty to apply, the unit must be installed and used according to its
written instructions. If service is necessary, it must be performed by Russound. The unit must be returned to Russound at the
owners expense and with prior written permission. Accidental damage and shipping damage are not considered defects under
the terms of the warranty. Russound assumes no responsibility for defects resulting from abuse or servicing performed by an
agency or person not specifically authorized in writing by Russound. Damage to or destruction of components due to
improper use voids the warranty. In these cases the repair will be made at the owners expense. To return for repairs, the unit
must be shipped to Russound at the owners expense, along with a note explaining the nature of the service required. Be sure
to pack in a corrugated container with at least 3 inches of resilient material to protect the unit from damage in transit.
T
ROUBLESHOOTING
IR R O
EMOTE UTPUT
4 3 2 1
PLUG-IN SEQUENCE
SIGNAL
TO SECOND
IR RECEIVER
6
GROUND
CONNECT TO
846C POWER
SUPPLY
LOCK B ONNECTING C
ONFIRM C IR
I 857
NFRARED
MITTERS E
5 4 3 2 1
845.1 MICRO EMITTERS
TO IR CONTROLLED
EQUIPMENT
W
ARRANTY
15