Mira REALM Installation And User Manual page 13

9. Temporarily fit the rigid riser pipe and
horizontal arm and wall bracket to
the shower control outlet and mark
the position of the wall bracket. Use
a spirit level to ensure the pipe is
vertical.
Note that the horizontal arm can be
shortened if required. De-burr the
pipe ends before making the final
connection.
10. Fix the wall bracket, rigid riser
pipe and hand-tighten the three
compression fittings on the shower
control outlet and horizontal arm.
Apply a further 3/4 to 1 1/4 turns
to each compression nut, with a
spanner, to effect a seal.
Note! Care must be taken when
tightening compression nuts so
that you do not damage the plated
surfaces.
11. Thoroughly flush the outlet pipework
before connecting the shower head.
Slide the compression nut over
the horizontal arm and make the
connection to the shower head.
Fixing
Screws
Olive
Horizontal Arm
13
Wall Plugs
Compression
Nut
Rigid Riser Pipe
Shower Head