Requirements; Before Startup; Physical Installation - Planet Networking & Communication XRT-501 Quick Installation Manual

Internet broadband router

Table of Contents

1. Requirements

l DSL or Cable modem for broadband Internet access.

l Network cables. Use standard 10/100/1000Base-T network (UTP) cables with

RJ45 connectors.

l TCP/IP network protocol installed on each PC.

Setup your network as shown in the setup diagram below

1. Use standard LAN cables to connect PCs to the Switching Hub ports on the

XRT-501, or you can directly connect PCs to XRT-501, you may use 10Base-T,

100Base-TX, or 1000Base-T connections, and all connection types can be used

simultaneously.

2. If required, connect any port to a normal port on another Hub, using a stan-

dard LAN cable. Any LAN port on the XRT-501 will automatically function as an

"Uplink" port when required.

3. Connect the DSL or Cable modem to the WAN port on the XRT-501. Use the

cable supplied with your DSL/Cable modem. If no cable was supplied, use a

standard cable.

4. Connect the supplied Power Adapter and power on.

5. Check the LEDs

Table of Contents