Table of Contents
Advertisement
3. NAME OF EACH PART
No.
Name
1) Corresponding axis LED display
2) CC-Link status LED display
3) Transmission speed setting switch Sets the data communication speed.
4) Station number setting switch
5) LED display mode select switch
6) Reset switch
7) Drive unit connectors (AX1, AX2)
8) 17 segment LED
9) RS-422 peripheral connector
10) Terminal block
Maintenance connector for
11)
manufacturer
9)
10)
*1
1)
2)
3)
4)
8)
Indicates the axis for the "8)17 segment LED"
message.
Shows the power supply and data communication
conditions.
Sets the D75P2 station number.
Display information is switched between "1)
Corresponding axis LED display" and "8) 17 segment
LED" each time the switch is pressed.
When pressed, it initializes input signals, remote
registers and operation processing.
For connection to the drive unit, mechanical system
input and manual pulse generator.
Displays messages indicating the operation status
according to the mode.
For connection to peripheral devices.
For connection to the master module.
Terminal block
assignment diagram
1
DA
2
DB
This connector is for manufacturer use only. Do not
open the cover.
2
11)
5)
6)
7)
Description
3
5
7
DG
+24V 24G
4
6
SLD (FG)
Advertisement
Table of Contents
