Garmin 500W Series Instructions Manual page 8

The 500W unit is installed in the rack by sliding it straight in until it stops, about 1 inch short of the final
position. Insert the hex drive tool into the access hole at the bottom of the unit face. Rotate the hex tool
clockwise while pressing on the left side of the bezel until the unit is firmly seated in the rack.
Note: There are no special handling requirements for the 500W series units.
2.7.2 Flight Stream 210 (If Installed)
See Figure 1 when performing the following steps:
Removal
1. Locate and open the BT Link circuit breaker.
2. Unscrew the two jackscrews on the Flight Stream 210 connector. Remove connector.
3. Remove the four #6 mounting screws to remove the Flight Stream 210.
Reinstallation
1. Check that the BT Link circuit breaker is open.
2. Reinstall the Flight Stream 210 using the four previously removed #6 mounting screws.
3. Tighten fasteners until snug, plus an additional 1/4 turn.
Note: Ensure that the Flight Stream 210 is mounted with the arrow pointing in the direction of flight.
4. Attach the connector, tightening the two jackscrews.
5. Close the BT Link circuit breaker.
6. Complete the interface checkout procedures contained in Section 5.5.8 of the 500W Series
Installation Manual.
Figure 1. Flight Stream 210 Assembly Overview (Bonding Strap Not Shown)
500W Series
Instructions for Continued Airworthiness
190-00357-65 Rev. D
Page 8 of 12