Information - Runco PLASMAWALL XP-50DHD Installation And Operation Manual

Operation

Information

Information
Signal
System
Field Service
Manufacturing
Note
To reset the Custom 1 or Custom 2/THX memory preset to its factory-default state, select
it, press or to highlight Reset and press ENTER.
➤
Signal / System: Select Information from the Main Menu, then choose either Signal or
System to display information about the current input signal (resolution, frequency, type et
cetera) and installed firmware versions, as well as other information that uniquely identifies
your DHD Controller and display device.
Should you ever need to contact Runco Technical Support, this information will help them
answer your questions or resolve product performance issues.
Signal
Input Source
Signal Format
Input Resolution
Vertical Freq
Horizontal Freq
Pixel Clock
Color Space
Sync Type
Memory Preset
Field Service / Manufacturing: The Field Service and Manufacturing menus are
password-protected and intended for use only by Runco service personnel and factory
technicians.
To save the settings for the current input and display mode to the
ISF Night or ISF Day memory preset, select Save ISF Night or Save
ISF Day from the Calibration menu (refer to Save ISF Night/Save
ISF Day on page 51).
HDMI 1
1080p/60
1920x1080
59.94 Hz
67.500 kHz
148.500 MHz
REC709
Separate
ISF Night
48 PlasmaWall XP Series Installation/Operation Manual
System
Model DHD3
Display Name XP-50DHD
Output Resolution 1920x1080
Serial Number 00000000
Boot Version 3.0
Firmware Version 3.4
Micro Version 3.3