Runco High Definition Owner's Operating Manual page 59

Remote Control: The Remote Control menu shows you the primary and secondary
infrared (IR) codes to which the DHD Controller will respond. By default, both are set to
17. You can change these codes if either:
• Another device in the theater (a DVD player, for example) is responding to commands
from the DHD Controller remote control (Figure 2-7) in ways that are unpredictable or
undesirable.
• You have multiple DHD Controllers and want to control them independently, as
opposed to broadcasting commands from a single remote to all of them. In this
scenario, you can use multiple remotes programmed to use different IR codes. Or, you
can use a single remote and change the IR code as needed to address a specific
device.
Use the DHD Controller front-panel keypad to change its IR code.
Tip
Then, change the code sent by the remote to match as described
below.
Do not change the "Type" setting in this menu.
Note
When you change a remote code on the DHD Controller, you must re-program your
remote control to send that same code. To do this:
1. Using a straightened paper clip or similar object,
press and hold the CODE button on the remote
control for approximately three seconds, or until the
LED on the remote lights solid red.
– OR –
If your remote control unit does not have a CODE
button, press and hold the LIGHT button on the
remote control for approximately three seconds, or
until the LED on the remote lights solid red.
2. Enter a new two-digit code between 00 and 31 inclusive. Include a leading zero for
single-digit codes; for example, enter 9 as "09."
3. The LED turns off to confirm the code change. If you enter an invalid code, the LED
flashes for three or four seconds. Try again, entering a valid code.
PlasmaWall XP Series Owner's Operating Manual
RETURN
EXIT
47
Operation