Wireless Remote Controller - LG AMNC12GTRA2 Owner's Manual

PRODUCT INTRODUCTION
10

Wireless Remote Controller

This air-conditioner is equipped with wireless remote controller basically. But if you want to be
available with wired remote controller, you pay for it.
1
2
3
4
5
6
7
8
9
CAUTION
!
of handling the Remote Controller
• Aim at the signal receiver on the wired remote controller so as to operate.
• The remote control signal can be received at a distance of up to about 7m.
• Be sure that there are no obstructions between the remote controller and the signal receptor.
• Do not drop or throw the remote controller.
• Do not place the remote controller in a location exposed to direct sunlight, or near the heating
unit, or any other heat source.
• Block a strong light over the signal receptor with a curtain or etc. so as to prevent the abnormal
operation. (ex:electronic quick start, ELBA, inverter type fluorescent lamp)
!
NOTE
* The wireless remote controller do not operate the swirl mode.(4Way Type)
* The actual product can be different from above contents depending upon model type.
1
VANE ANGLE Button
Used to set each vane angle.
2
FUNCTION SETTING Button
Used to set or clear Auto Clean,
Smart Clean, Electric heater or Indi-
vidual vane angle control.
3
ON/OFF Button
10
Used to turn on/off the unit.
11
12
4
JET COOL Button
Speed cooling operates super high
13
fan speed.
5
LEFT/RIGHT AIRFLOW Button
14
(OPTIONAL)
Used to set the desired left/right(hori-
15
16
zontal) airflow direction.
6
UP/DOWN AIRFLOW Button
17
Used to stop or start louver move-
ment and set the desired up/down
airflow direction.
7
ON TIMER Button
Used to set the time of starting oper-
ation.
8
SLEEP TIMER Button
Used to set the time of sleeping op-
eration.
9
SET / CLEAR Button
Used to set/clear the timer.
Used to set the current time(if it input
for 3sec.)
10
PLASMA Button (OPTIONAL)
Used to start or stop the plasma-pu-
rification function.
11
ROOM TEMPERATURE SETTING
Button
Used to select the room tempera-
ture.
12
OPERATION MODE SELECTION
Button
Used to select the operation mode.
13
INDOOR FAN SPEED SELECTION
Button
Used to select fan speed in four
steps low, medium, high and chaos.
14
ROOM TEMPERATURE CHECKING
Button
Used to check the room tempera-
ture.
15
OFF TIMER Button
Used to set the time of stopping op-
eration.
16
TIMER SETTING(Up/Down)/LIGHT
Button
Used to set the timer.
Used to adjust the brightness.(if it is
not time adjust mode)
17
RESET Button
Used to reset the remote controller.