Snooze Function; Radio Operation - Jensen QiCR-50 User Manual

When the alarm sounds, tap the DIMMER/SNOOZE/SLEEP BUTTON (#5) to
temporarily turn off the alarm and activate the snooze function, the alarm will stop
and sound again 9 minutes later. If you tap the DIMMER/SNOOZE/SLEEP BUTTON
(#5) again, the alarm will temporarily turn off again and sound again in 9 minutes
and so on. The alarm sound will turn off after one hour.
NOTES :
• To temporarily silence the alarm, press the DIMMER/SNOOZE/SLEEP BUTTON
(#5). The alarm will sound again when the snooze period (9 minutes) expires.
• The corresponding Alarm 1 or Alarm 2 indicator (alarm or radio) flashes on the
display during the snooze period.
• To cancel the snooze period and the alarm, press
Listening to the radio
/ MODE BUTTON (#8 ) repeatedly to Turn On the unit and select Radio
1. Tap the
mode, frequency will show on the
2. Press and hold the MIN /
search for the next / previous available station.
3. If the reception is poor, try Manual Tuning to fine-tune the station. Tap the MIN /
BUTTON (#4) OR HOUR /
frequency band.
/
4. Adjust the
sound level.
5. When you have finished listening, press and hold
turn the radio off.
NOTES:
• The LED DISPLAY (#16)
a few seconds.
• When listening to the radio, you can check the frequency of the station you are
listening to by tapping the MIN /
The unit will automatically change back to the time after a few seconds.
Setting the Radio Station Presets
The unit allows you to store up to
1. Press the / MODE BUTTON (#8 ) repeatedly to turn on the unit and select Radio
Mode.
2. Tune to the radio station you want to store in memory.
3. Press and hold the
"P01" will be flashing on the
4. To change the preset channel number location,
OR HOUR / BUTTON (#3) to step through the preset locations.
5. To confirm the preset location, press
6. To store another station presets, repeat steps 2-5 above.
RECALLING A PRESET STATION
In Radio mode, press the
preset channel.
TIPS FOR BEST RADIO RECEPTION
FM - If FM reception is weak, fully extend the wire antenna and vary the position and
location of the antenna until you find the strongest signal.

SNOOZE FUNCTION

RADIO OPERATION

LED DISPLAY (#16)
BUTTON (#4) OR HOUR /
BUTTON (#3) briefly to manually tune through the
BUTTON
(#7) and
will automatically switch back to showing the time after
BUTTON (#4) OR HOUR /
10 stations for easy recall at any time.
/ MEM / M + BUTTON (#2). The preset channel number
LED DISPLAY
/ MEM / M + BUTTON (#2) repeatedly to select the
E-9
/ MODE BUTTON (#8).
.
/ BUTTON
(#6) to obtain the desired
/ MODE BUTTON (#8 ) to
(#16).
press the MIN /
/ MEM / M + BUTTON (#2).
BUTTON (#3) to
BUTTON (#3).
BUTTON (#4)