Snooze Function; Radio Operation - Jensen JCR-255 User Manual

When the alarm sounds, tap the SNOOZE BUTTON (#15) on the top panel to
temporarily turn off the alarm and activate the SNOOZE function. The alarm will stop
and turn on again 9 minutes later. This can be repeated when the alarm sounds again.
NOTES:
• The corresponding Alarm 1 or Alarm 2 indicator (alarm/radio/vibrator) flashes on the
display during the snooze period.
• To cancel the SNOOZE function and the alarm, press any button except the
SNOOZE BUTTON (#15).
Listening to the radio
1. Press the RADIO ON BUTTON (#13) to turn on the radio.
2. Slide the RADIO BAND SELECTOR (#25) located on the back of the unit to select
the AM or FM band.
3. The frequency will show on the LED display. Tap the
DOWN BUTTON (#11) to adjust frequency.
4. Press and hold the
automatically tune to the next or previous available station.
5. Tap the VOLUME RADIO BUTTON (#12). The volume level will show on the LED
display.
6. Tap the UP BUTTON ( #19) or
volume level.
7. Press the RADIO OFF BUTTON (#15) to turn the radio OFF.
Notes:
• Use manual tuning to select weaker stations that might be skipped during
automatic tuning.
• If the automatic tuning does not stop on the exact frequency of the station, for
example, it stops on 88.9 MHz instead of 88.8 MHz, use the manual tuning method
to "fine tune" to the exact frequency of the desired station.
• In radio mode, the display will automatically switch back to showing the time after a
few seconds.
• When listening to the radio, you can check the frequency of the station you are
listening by tapping the RADIO ON BUTTON (#13) once.
Tips for best radio reception
AM - The AM antenna is built inside the radio. If AM reception is weak, change the
position of the unit until the internal antenna picks up the strongest signal.
FM - If FM reception is weak, fully extend the FM ANTENNA (#24) and vary the
position and location of the antenna until you find the strongest signal.
To set / recall the radio presets
The unit allows you to store up to 10
any time.
1. Press the RADIO ON BUTTON (#13) to turn on the radio.
2. Slide the RADIO BAND SELECTOR (#25) to select AM or FM band.
3. Tap the UP BUTTON ( #19) or
station.

SNOOZE FUNCTION

RADIO OPERATION

UP BUTTON ( #19) or
DOWN BUTTON (#11) to obtain the desired
FM stations and 10 AM stations for easy recall at
DOWN BUTTON (#11) to select the desired
E-10
UP BUTTON ( #19) or
DOWN BUTTON (#11) to