Product Does Not Appear In Mac Printer Window; Cannot Print Over A Network - Epson EcoTank L396 Wireless Installation Manual

Hide thumbs Also See for EcoTank L396:

Table of Contents

Note: If you are using a 5 GHz wireless router, set the router to operate in dual band (2.4 GHz and

5 GHz) mode. If your router uses a single network name (SSID) for both the 2.4 GHz and 5 GHz band,

give each band its own network name (SSID) instead, such as Home Network 2.4 GHz and Home

Network 5 GHz. See your router documentation or contact your internet service provider for

instructions.

• Check to see if your wireless router or access point has an enabled Privacy Separator function that is

preventing detection of your device over the network. See your router or access point documentation

for instructions on disabling the Privacy Separator function.

Parent topic:

Product Does Not Appear in Mac Printer Window

If your product does not appear in the Mac printer window, try these solutions:

• Turn your product off, wait 30 seconds, then turn it back on again.

• If you are connecting the product via Wi-Fi Protected Setup (WPS) and the

product is not solid green, make sure you press the Wi-Fi button on the product within 2 minutes of

pressing the WPS button on your router. Hold down the Wi-Fi button on the product for 3 seconds.

• If you are connecting the product wirelessly via EpsonNet Setup and the

is not solid green, make sure your product software was installed correctly. If necessary, reinstall your

software.

Note: If you are using a 5 GHz wireless router, set the router to operate in dual band (2.4 GHz and

5 GHz) mode. If your router uses a single network name (SSID) for both the 2.4 GHz and 5 GHz band,

give each band its own network name (SSID) instead, such as Home Network 2.4 GHz and Home

Network 5 GHz. See your router documentation or contact your internet service provider for instructions.

Parent topic:

If you cannot print over a network, try these solutions:

• Make sure that your product is turned on.

• Make sure you install your product's network software as described in your product documentation.

• Print a network status sheet and verify that the network settings are correct. If the network status is

Disconnected, check any cable connections and turn your product off and then on again.

Solving Network Problems

Wi-Fi light on your

Wi-Fi light on your product

Table of Contents