Seagate NWD-WLP4-200 User Manual page 17

www.seagate.com
Figure 7 Nytro WarpDrive 6203 Card LED Diagram
Table 2 Status Indicators on a Running System
Name Color
Activity Green
Life Green
Yellow
Red
Status Green
Yellow
Red
Seagate Nytro WarpDrive and Nytro XP6000, Rev. 1.12
On, blinking – Indicates data activity on the card. No action required.
On, steady – Card has sufficient life remaining for programming and erasing the Flash memory. No
action required.
On, steady – Card has approximately 10% or less of life remaining for programming and erasing the Flash
memory. Plan for replacements.
On, steady – Card has no program or erase cycles left. Data can be read, but writes are at risk. Back up data and
copy to a new Nytro WarpDrive card.
On, steady – Normal.
On, blinking – Lets the user locate a specific Nytro WarpDrive card in a rack of servers.
On, steady – Warning. One of the following conditions applies:
Temperature warning. If this condition persists, you might damage your Nytro WarpDrive card. Increase

cooling for the card or shut down your system to prevent damage.
Other component issues: Run the list and health commands in the ddcli utility to determine which

component has an issue.
On, blinking – Firmware fault code:
Run the ddcli utility to determine which component has an issue.

 If no information appears, reboot the system and retry.
If no information appears, contact

On, steady – One of the following conditions applies:
 One or more SSDs failed (IT mode).
 At least one SSD has exceeded its temperature.
 Failed RAID volume (DD mode).
 No RAID volume is configured (DD mode).
Backup power store failed.

Other component issues: Run the list and health commands in the ddcli utility to determine which

component has an issue.
If no information appears, reboot the system and retry the utility (DD mode).
LED Description
Seagate Technology Support
Nytro WarpDrive 6203 Card Characteristics
Services.
17