Names Of Parts - Daikin CTXJ25RVMAW Operation Manual

Names of Parts

Indoor Unit
Upper front
panel
Air outlet
Lower front panel
• It is located on the back of the
upper front panel during operation.
Louvres (vertical blades)
• The louvres are inside of the air outlet.
Multi-monitor lamp and
TIMER lamp
Multi-monitor lamp
• The lamp colour changes according to
the operation.
Operation Multi-monitor lamp
AUTO*
DRY
COOL
HEAT*
FAN
TIMER
* Only for HEAT PUMP models
TIMER lamp
• When operation by timer has been set, the multi-monitor lamp
periodically changes to orange. After lighting orange for about
5 seconds, it returns to the colour of the operation mode.
The multi-monitor lamp will turn orange on and off in cyclic
manner while the air conditioner is not in operation.
TIMER lamp colour: For COOL
2 sec. 2 sec.
5 sec.
Orange
Blue
5
Air inlet
Page 13
Red/Blue
Green
Blue
Red
White
Orange
TIMER lamp colour
DRY: Green
2 sec.
COOL: Blue
3 min. 5 sec.
HEAT: Red
White
FAN:
Off
Stop:
Flaps
(horizontal
blades)
Page 13
Display
INTELLIGENT EYE lamp
(green)
Signal receiver and Indoor
unit ON/OFF switch
Signal receiver
• Receives signals from the remote
controller.
• When the unit receives a signal, you will
hear a beep sound.
Indoor unit ON/OFF switch
• Press this switch once to start operation.
Press once again to stop it.
• For the operation mode setting, refer to the following
table.
Model
HEAT PUMP
Orange
COOLING ONLY
Orange
• This switch can be used when the remote controller is
Orange
missing.
Orange
Orange
INTELLIGENT EYE
sensor
• Detects the movements of
people and automatically
switches between normal
operation and energy saving
operation. Page 15-17
Indoor temperature
sensor
• Detects the air temperature
around the unit.
Page 16
Case Sound type
Operation start beep-beep
Setting changed beep
Operation stop long beep
Temperature
Mode
setting
AUTO 25.0°C
COOL 22.0°C
Airfl ow
rate
AUTO
AUTO