Preparation Before Operation - Daikin CTXJ25RVMAW Operation Manual

Preparation Before Operation

CAUTION
Incorrect handling of batteries can result in injury from battery leakage, rupturing or heating, or lead to equipment failure.
Please observe the following precautions and use safely.
• If the alkaline solution from the batteries should get in the eyes, do not rub the eyes. Instead, immediately flush the eyes with tap water and
seek the attention of a medical professional.
• Keep batteries out of reach of children. In the event that batteries are swallowed, seek the immediate attention of a medical professional.
• Do not expose batteries to heat or fire. Do not disassemble or modify batteries. The insulation or gas release vent inside the battery may be
damaged, resulting in battery leakage, rupturing, or heating.
• Do not damage or peel off labels on the batteries.
2
+
Position
–
correctly!
3
1
Grip both
sides of the
front cover.
Remote controller
Screws
Remote
controller holder
NOTE
„ Notes on batteries
• To avoid possible injury or damage from battery leakage or rupturing, remove the batteries when not using the product for long periods of time.
• The standard replacement time is about 1 year. Both batteries should be replaced at the same time. Be sure to replace them with new size
AAA.LR03 (alkaline) batteries.
• When battery power has run out, "
battery consumption is accelerated owing usage conditions, signal reception may decline before the LCD begins blinking.
• The batteries supplied with the remote controller are for initial operation. The batteries may run out in less than 1 year.
„ Notes on remote controller
• Never expose the remote controller to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as inverter-type lamps) is in the room. Consult
your dealer if that is the case.
• If the remote controller activates other electric devices, move them away, or consult your dealer.
9
„ To insert the batteries
and
1.
Slide the front cover to take it off.
2.
Insert 2 dry batteries AAA.LR03 (alkaline).
3.
Replace the front cover.
„ To attach the remote controller holder to a wall
1.
Choose a place from where the signals
reach the unit.
2.
Attach the holder to a wall, a pillar, or similar
location with the screws supplied with the
holder.
3.
Place the remote controller in the remote
controller holder.
„ Turn on the circuit breaker
• After the power is turned on, the flaps of the indoor unit open and close once to
set the reference position.
" will begin blinking on the LCD as an alert that the batteries need replacing. In some cases, when