Burst Of Steam - Rowenta Sew 'n' Press Sew 'n' Press Steam Iron Instructions For Use Manual

VARIABLE STEAM FUNCTION
Set the variable steam control to required
steam volume. Steam can only be produced
when the thermostat is in the red cotton/
m a x
m in
linen zone. Allow iron to heat up (light goes
out) before activating the variable steam
control. Reduce or set variable steam to
min. when ironing at low temperatures to
avoid water leakage or spitting.
Iron ready for steam ironing
Steam is produced as soon as the iron is held horizontally.
Steam off
Steam generation can be interrupted:
by standing the iron on its heel or
by sliding the variable steam control completely to min
SPRAY SETTING

BURST OF STEAM

6
Ensure there is water in the tank.
Moistening the fabric with the spray will
make wrinkle removal easier.
Press the spray button down slowly for a
jet or quickly and strongly for a mist.
Do not spray silk, etc.
To remove stubborn wrinkles or press in
a sharp crease, use the burst of steam
button.
Press the button firmly, a strong burst of
steam penetrates deep into the fabric.
Leave an interval of at least four seconds
between pressing the burst of steam
button.
With water in the tank, the burst of
steam button can be used as soon as the
steam ironing temperature has been
reached ( )