Ricoh SP C260DNW Setup Manual page 9

Easy Setup Using the Wi-Fi Setup Wizard
From the control panel of this machine, you can also configure the
wireless LAN settings for the machine.
The following item is necessary to set up a wireless
connection.
● Router (access point)
Checking the SSID and Encryption key
The SSID and Encryption key for the router (access point) may be
printed on a label affixed to the router (access point). For details about
the SSID and Encryption key, refer to the router (access point) manual.
Confirm the SSID and Encryption key, and write them down on the
blank space as shown below.
SSID:
Encryption key:
Configuring Settings Using the Control Panel
● Before doing the following procedure, install the printer
driver according to the procedure on page 5
"Connecting the Machine (USB/Network)".
● Make sure the Ethernet cable is not connected to the
machine.
1. Check that the router (access point) is working correctly.
2. Press the [Menu] key.
3. Press the [ ] or [ ] key to select [Host Interface], and then
press the [OK] key.
4. Press the [ ] or [ ] key to select [Network Setting], and
then press the [OK] key.
5. Press the [ ] or [ ] key to select [Wi-Fi Config.], and then
press the [OK] key.
SSID :XXXXXXXXXXXXX
Encryption key :XXXXXXXXXXXXX
DSG099
DUE129
6. Press the [ ] or [ ] key to select [Wi-Fi], and then press
the [OK] key.
7. Press the [ ] or [ ] key to select [Active], and then press
the [OK] key.
8. Press the [Menu] key to return to the Initial screen.
9. Turn off the machine, and then turn it back on.
10. Press the [Menu] key.
11. Press the [ ] or [ ] key to select [Host Interface], and then
press the [OK] key.
12. Press the [ ] or [ ] key to select [Network Setting], and
then press the [OK] key.
13. Press the [ ] or [ ] key to select [Wi-Fi Config.], and then
press the [OK] key.
14. Press the [ ] or [ ] key to select [Setup Wizard], and then
press the [OK] key.
15. Press the [ ] or [ ] key to select SSID of the router (access
point) from the searched SSID list, and then press the [OK]
key.
16. Press the [ ] or [ ] key to select the authentication
method, and then press the [OK] key.
The next steps differ depending on the authentication method
that you have selected. Proceed to Step 17 of the appropriate
section.
• If the authentication method is set to [WPA2-PSK] or [Mixed Mode]
• If the authentication method is set to [Open System] or [Shared Key]
DUE129
7