Using The Battery - Sanyo SCP-4900 Operating Manual

Using the Battery

Installing the Battery
Your Sprint PCS Phone comes with a Lithium Ion battery. Follow these steps to install
it:
1. Place the battery into the space beneath the antenna with the metal contacts at the
bottom, facing downward.
2. Gently press down until it's in place and the battery release latch snaps.
Removing the Battery
To remove your battery for charging or for another reason, follow these easy steps:
1. Make sure the power is off so that you don't lose any stored numbers or messages.
2. Press up the battery release latch and hold the battery, then pull it up and out at a
45-degree angle.
Charging the Battery
Your Sprint PCS Phone comes with a rechargeable battery. You should charge the
battery as soon as possible so you can begin using your phone.
Keeping track of your battery's charge is important. If your battery level becomes too
low, your phone automatically turns off and you'll lose everything you were just working
on. For a quick check of your phone's battery level, glance at the battery charge
indicator located on your phone's display screen. If the battery charge gets too low, the
blank battery icon appears and the phone sounds a warning tone.
Always use a Sprint PCS-approved Desktop Charger, Travel Charger or Vehicle Power
Adapter to charge your battery.
Warning! Using the wrong battery charger could cause damage to your phone and void
the warranty.
10