Table of Contents
Advertisement
a.
Using a screwdriver or a coin, turn each of the screws toward the middle of the blade server
until they are in the unlocked position.
b.
While you lift the back of the access panel, slide the panel away from the bezel.
Step 3.
Remove the hypervisor interposer:
a.
Locate the hypervisor interposer on the system board (see "Major components of the blade
server" on page 11).
b.
Press down on the front edge of the hypervisor interposer to disengage the hypervisor
interposer from the hypervisor interposer card guide.
c.
Carefully lift the hypervisor interposer up from the system board.
Step 4.
Touch the static-protective package that contains the hypervisor key to any unpainted metal
surface on the BladeCenter unit or any unpainted metal surface on any other grounded rack
component in the rack in which you are installing the hypervisor key for at least 2 seconds; then,
remove the USB module from its package.
Step 5.
Install the hypervisor key into the hypervisor adapter:
a.
Orient the connector on the hypervisor key with the connector on the hypervisor adapter.
b.
Use your fingers to push the hypervisor key into the hypervisor adapter.
Step 6.
Install the hypervisor adapter:
a.
Orient the connector on the hypervisor interposer with the interposer connector on the system
board, aligning the pins on the side of the hypervisor interposer with the pinholes on the
interposer connector (see "Blade server connectors - BladeCenter HX5" on page 20).
b.
Use your fingers to push the adapter into the connector on the blade server.
Attention: Be careful not to damage the pins on the hypervisor interposer.
Step 7.
Install the access panel if you have standard heat sinks installed.
Note: If you have the tall heat sinks installed, you do not need to install the access panel.
.
Chapter 3
Installing optional devices
45
Advertisement
Table of Contents
