Amana PTAC Service Instructions Manual page 29

PROPER INSTALLATION
1. Press and hold OFF button on the PTAC until appears.
2. Press and then immediately release the white tactile
button on the back of the DS01* thermostat.
now be displayed on the PTAC LED display. If
not show on the display in 1-2 seconds, then press and
release the white button a second time. Skip this step
if there is no thermostat.
3. Press and then immediately release the white tactile
button on the back of the DD01* motion sensor.
should now be displayed on the PTAC LED display.
If or does not show on the display in 1-2 sec-
onds, then press and release the white button a second
time. NOTE: If both a DD01* and a DS01* are being
bound, then the display will show
Skip if there is no motion sensor.
4. Press "OFF" on the PTAC touchpad to exit the binding
sequence.
5. Slide top of the thermostat down onto the wall plate
and then snap into place.
6. Provided optional security screws may be used in lower
corners of the thermostat.
OPTIONAL
SECURITY SCREWS
7. Snap motion sensor onto motion sensor mounting plate.
8. Provided optional security screws may be installed on
right and left side of the sensor.
9. If you wish to change from the factory default settings,
configure the device or devices that were bound. See
the next section for configuration choices.
NOTE: If a wireless device is replaced or added, all de-
vices (including those previously bound) will need to be
bound/re-bound to the unit. See directions above.
ENTERING ROOM NUMBER (SKIP IF NOT USING
DP01* FRONT DESK PLATFORM)
should
1. The PTAC control can be set for a 4-digit room num-
does
ber. To select the first two digits (floor), press the
HEAT
or
up
2. To select the last two digits of the room number,
press the HEAT
.
press the up and down
2 digits of the room number.
For example for Room "201", press the HEAT
key until
rows to select "02":
Next to select the last two digits of the room number,
press the HEAT
press the up and down
=
3. If a room contains more than one unit (a suite), a suffix
must also be entered to identify which unit is in the
main room and which unit(s) are in bedroom(s). Mas-
ter unit ALWAYS MUST have a 01 suffix and slaves a
suffix or 02, 03, etc. To select the room # suffix, while
still in configuration mode, press the HEAT
key until
For the unit serving the main living area in room 224,
key until appears, then press the
down arrows to select the first two digits.
key until
arrows to select the last
appears, then press the up
=
key until
arrows to select "01":
.
appears. Then press the up and down
arrows to select the room # suffix. Example:
appears, then
down ar-
.
appears, then
29