SCW-R500
1/9/99 12:06 PM
Page 12
MAKING CALLS
1
First, check to see that your FWT Phone is turned on.
If the Power LED is lit, that means the power is on.
2
Pick up the handset.
You hear a dial tone.
3
Using the number keypad, dial the desired telephone number.
When you finish inputting phone number, you have to press
If you don't press
button, A call is not connected.
4
When the other person answers, begin your conversation.
5
To end the call, replace the handset.
NOTE: • You can dial by 32 digit including
• You can dial emergency call by pressing and holding
inputting any digits.
You can't change the emergency call number.
RECEIVING CALLS
The terminal signals the telephone(s) to ring when an incoming call is
detected. Pick up the telephone handset and begin talking into the
microphone on the handset.
• To disconnect when you're through, replace the handset.
NOTE: • Be sure the phone's ringer is enabled.
• If you heard incoming call in picking up the handset, you can receive
the call by pressing any digit key.
button.
.
without
Advanced Feature
Adjusting Volume
Terminal Reset
Restricting Use of the Phone
Setting Warning Beeps
Changing the Lock Code