Specifications; Assembly - CEN-TECH 63873 Owner's Manual & Safety Instructions

Specifications

Electrical Rating
Charge Settings
Starter Settings
Battery Cables
Power Cord
Assembly Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy: Unplug the charger, disconnect any battery,
and allow charger to cool completely before assembling or making any adjustments to the charger.
Note: For additional information regarding the parts listed in the
following pages, refer to Parts List and Diagram on page 14.
Attach Wheels to Axle
1. Push Cotter Pin (41) through hole on outside left
end of Axle (42). Bend ends of Cotter Pin up.
Slide one Wheel (21) onto Axle, against Cotter Pin,
make sure the Hub cap side is facing out.
2. Push Cotter Pin through hole on Axle next
to Wheel. Bend ends of Cotter Pin up.
1
5
Hubcap
Wheel
Page 6
120 V AC / 60 H z / 10 A (40A for boost)
6V
2 A
40 A Boost
12V, 200A
5 second maximum with 180 second minimum rest
6'
Red = Positive
Black = Negative
6' 5"
2
cotter
pin
For technical questions, please call 1-888-866-5797.
12V
2 A
10A
40 A Boost
3. Slide other Wheel onto Axle. Push Cotter
Pin through hole on outside right end of
Axle. Bend ends of Cotter Pin up.
4. Slide Wheel against Cotter Pin, make sure
the Hub cap side is facing out.
Push Cotter Pin through hole on Axle next
to Wheel. Bend ends of Cotter Pin up.
5. Snap Hubcaps (22) onto Axle.
Axle
4 3
Item 63873