CEN-TECH 63873 Owner's Manual & Safety Instructions page 11

charging battery Outside Vehicle
A SpARK NEAR bATTERy MAy cAUSE bATTERy EXpLOSION.
TO REDUcE RISK OF A SpARK NEAR bATTERy FOLLOW THESE INSTRUcTIONS EXAcTLy.
DO NOT pLUG IN cHARGER/STARTER UNTIL DIREcTED TO DO SO.
TO pREVENT SERIOUS INJURy:
Wear ANSI-approved splash-resistant safety goggles and heavy-duty rubber work gloves
whenever connecting, disconnecting, or working near battery.
battery acid can cause permanent blindness.
WARNING! Do not use Start setting to
charge batteries. Use to jump start only.
cOLD bATTERIES: Begin charging at lowest rate,
increase rate as battery reaches normal temperature.
DO NOT cHARGE A FROZEN bATTERy.
1. Unplug Charger/Starter.
2. Attach at least a 24-inch-long
6-gauge (AWG) insulated battery cable to
NEGATIVE (NEG, N, –) battery post.
3. Connect POSITIVE (RED) charger clip to
POSITIVE (POS, P, +) post of battery.
cAUTION! Do not face battery when
making final connection.
4. Position yourself and free end of battery
cable as far away from battery as possible –
then connect NEGATIVE (BLACK) charger
clip to free end of battery cable.
Item 63873 For technical questions, please call 1-888-866-5797.
5. Plug Charger/Starter into grounded 120V receptacle.
6. Turn Power Switch on.
7. Press Function Select Button until desired function
lights up. Refer to Table b on page 9.
WARNING! Do not use 12V 200A Start
function for charging.
8. Press Start/Stop button to start function.
9. When finished, turn Power Switch
off and unplug power cord.
10. When disconnecting Charger/Starter, always
do so in reverse sequence of connecting
procedure and break first connection while
as far away from battery as practical.
11. After use clean, then store the Charger/
Starter indoors out of children's reach.
Page 11